www.delorie.com/archives/browse.cgi | search |
X-Authentication-Warning: | delorie.com: mail set sender to geda-user-bounces using -f |
X-Recipient: | geda-user AT delorie DOT com |
Message-ID: | <20170116234147.31491.qmail@rahul.net> |
Date: | Mon, 16 Jan 2017 15:41:47 -0800 |
To: | geda-user AT delorie DOT com |
Subject: | Re: [geda-user] Fill clearance? |
In-Reply-To: | <da23fee8-1f1c-0251-f2e4-11bc8140662a@ecosensory.com> |
References: | <20170116220309 DOT 27757 DOT qmail AT rahul DOT net> |
<da23fee8-1f1c-0251-f2e4-11bc8140662a AT ecosensory DOT com> | |
X-Mailer: | VM 7.19 under Emacs 23.4.1 |
From: | conover AT rahul DOT net (John Conover) |
MIME-Version: | 1.0 |
Reply-To: | geda-user AT delorie DOT com |
Errors-To: | nobody AT delorie DOT com |
X-Mailing-List: | geda-user AT delorie DOT com |
X-Unsubscribes-To: | listserv AT delorie DOT com |
Thanks, John. Select->Select all visable objects, on the layer works too. John John Griessen (john AT ecosensory DOT com) [via geda-user AT delorie DOT com] writes: > On 01/16/2017 04:03 PM, John Conover wrote: > > In pcb(1), a rectangular fill clearance is about 20 mils, fill to > > active circuitry. > > > > How can this be changed to 25 mil? > > draw a rectangle of component layer, > put it over the footprint, > area select all of that, > start action commands with : > > the type: > > changeclearsize(selectedobjects, 25, mil) > -- John Conover, conover AT rahul DOT net, http://www.johncon.com/
webmaster | delorie software privacy |
Copyright © 2019 by DJ Delorie | Updated Jul 2019 |