X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f X-Recipient: geda-user AT delorie DOT com Message-ID: <20170116234147.31491.qmail@rahul.net> Date: Mon, 16 Jan 2017 15:41:47 -0800 To: geda-user AT delorie DOT com Subject: Re: [geda-user] Fill clearance? In-Reply-To: References: <20170116220309 DOT 27757 DOT qmail AT rahul DOT net> X-Mailer: VM 7.19 under Emacs 23.4.1 From: conover AT rahul DOT net (John Conover) MIME-Version: 1.0 Content-Type: text/plain; charset=US-ASCII Content-Transfer-Encoding: 7bit Reply-To: geda-user AT delorie DOT com Errors-To: nobody AT delorie DOT com X-Mailing-List: geda-user AT delorie DOT com X-Unsubscribes-To: listserv AT delorie DOT com Precedence: bulk Thanks, John. Select->Select all visable objects, on the layer works too. John John Griessen (john AT ecosensory DOT com) [via geda-user AT delorie DOT com] writes: > On 01/16/2017 04:03 PM, John Conover wrote: > > In pcb(1), a rectangular fill clearance is about 20 mils, fill to > > active circuitry. > > > > How can this be changed to 25 mil? > > draw a rectangle of component layer, > put it over the footprint, > area select all of that, > start action commands with : > > the type: > > changeclearsize(selectedobjects, 25, mil) > -- John Conover, conover AT rahul DOT net, http://www.johncon.com/