www.delorie.com/archives/browse.cgi | search |
X-Authentication-Warning: | delorie.com: mail set sender to geda-user-bounces using -f |
X-Recipient: | geda-user AT delorie DOT com |
Date: | Thu, 10 Sep 2015 22:14:16 +0200 |
From: | Jan Kasprzak <kas AT fi DOT muni DOT cz> |
To: | geda-user AT delorie DOT com |
Subject: | [geda-user] 5630 LED footprint |
Message-ID: | <20150910201416.GG16766@fi.muni.cz> |
MIME-Version: | 1.0 |
X-Clacks-Overhead: | GNU Terry Pratchett |
User-Agent: | Mutt/1.5.20 (2009-12-10) |
X-Muni-Envelope-From: | kas AT fi DOT muni DOT cz |
X-Muni-Spam-TestIP: | 147.251.48.3 |
X-Muni-Local-IP: | yes |
X-Greylist: | Sender IP whitelisted, not delayed by milter-greylist-4.3.9 (minas.ics.muni.cz [147.251.4.35]); Thu, 10 Sep 2015 22:14:17 +0200 (CEST) |
X-Virus-Scanned: | clamav-milter 0.98.7 at minas |
X-Virus-Status: | Clean |
Reply-To: | geda-user AT delorie DOT com |
Hello, did anybody try to design a footprint for a 5630 SMD LED? The recommended design for the Lumileds one is here on page 7: http://www.lumileds.com/uploads/351/DS201-pdf In addition to that, I would like to modify the footprint for hand soldering, i.e. the middle thermal pad should have a hole in it, connected to a large pad on the opposite side of the PCB. The hole and the pad would then serve as a heat sink. What is the best way to do it? Thanks! -Yenya -- | Jan "Yenya" Kasprzak <kas at {fi.muni.cz - work | yenya.net - private}> | | New GPG 4096R/A45477D5 -- see http://www.fi.muni.cz/~kas/pgp-rollover.txt | | http://www.fi.muni.cz/~kas/ Journal: http://www.fi.muni.cz/~kas/blog/ | Smart data structures and dumb code works a lot better than the other way around. --Eric S. Raymond
webmaster | delorie software privacy |
Copyright © 2019 by DJ Delorie | Updated Jul 2019 |