X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
X-Virus-Status:	Clean
X-Virus-Scanned:	clamav-milter 0.98.4 at av02.lsn.net
Message-ID:	<55E46FDC.3020603@ecosensory.com>
Date:	Mon, 31 Aug 2015 10:16:44 -0500
From:	John Griessen <john AT ecosensory DOT com>
User-Agent:	Mozilla/5.0 (X11; Linux x86_64; rv:31.0) Gecko/20100101 Icedove/31.7.0
MIME-Version:	1.0
To:	geda-user AT delorie DOT com
Subject:	Re: [geda-user] Non-plated pin/via with copper annulus
References:	<CAGYR9vcipTvWXWUhxvdOSzOfuVhCxpNbcczeQF9nn4hr366G=Q AT mail DOT gmail DOT com> <20150831114226 DOT 13960 DOT qmail AT stuge DOT se> <CAGYR9vc54vm5n03eOmMwPOVxVVmf9RWM8XGZdO=LxCJepTwnBA AT mail DOT gmail DOT com> <CACwWb3AqdS_ymgDzeu1UxUR+wURjPT4eFE-sYvoi+8nVhf3kfw AT mail DOT gmail DOT com> <CAGYR9vcoyKnu0qGEupqnGz5NvGKzduCcrqSahaWrDcB65eAJLA AT mail DOT gmail DOT com> <alpine DOT DEB DOT 2 DOT 00 DOT 1508311606510 DOT 6924 AT igor2priv>
In-Reply-To:	<alpine.DEB.2.00.1508311606510.6924@igor2priv>
Reply-To:	geda-user AT delorie DOT com

On 08/31/2015 09:10 AM, gedau AT igor2 DOT repo DOT hu wrote:
> In case you go manual....
>
> You could place 4 single pins manually (2x2), then copy the whole block to place 3 more times and you ahve 4x4; repeat, and with 3
> more copies you have 8x8, etc. If you chose the copy origin point at the -1;-1 grid point relative, it's pretty fast.
>
> If it's just a switch board with no components and only vertical/horizontal lines on the two sides, I wouldn't make schematics,
> just do it all in PCB.
>
> I'd write a script only if I needed a series of boards with different geometries.


Sure.  That kind of arraying is often done in custom chip layout.
there are only so many tools you could get used enough to matter.
Or. . . "Never make a one shot tool."

- Raw text -