X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
Date:	Wed, 17 Dec 2014 15:13:10 -0500
Message-Id:	<201412172013.sBHKDAAx022528@envy.delorie.com>
From:	DJ Delorie <dj AT delorie DOT com>
To:	geda-user AT delorie DOT com
In-reply-to:
	<CALSZ9gqo83ZDuxZAYLaHp0=uXZvfe_1OougO9e4B6W9M86d3JA AT mail DOT gmail DOT com>
	(message from Rob Butts on Wed, 17 Dec 2014 12:21:17 -0500)
Subject:	Re: [geda-user] Nema 23 stepper motors
References:	<CALSZ9gqo83ZDuxZAYLaHp0=uXZvfe_1OougO9e4B6W9M86d3JA AT mail DOT gmail DOT com>
Reply-To:	geda-user AT delorie DOT com

Not sure if this is your problem, but on my lathe I need to *not* mesh
the gears completely together to make them run smoothly.  If the gears
press too much, the tip of one tooth hits the gullet of the opposite
gear, causing noise.  Only the sides of the teeth should touch.  I use
a piece of heavy paper between the lathe gears to separate them
"enough".

- Raw text -