www.delorie.com/archives/browse.cgi   search  
Mail Archives: geda-user/2012/03/19/04:37:51

X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient: geda-user AT delorie DOT com
X-Virus-Scanned: amavisd-new at neurotica.com
Message-ID: <4F66F040.6000604@neurotica.com>
Date: Mon, 19 Mar 2012 04:37:20 -0400
From: Dave McGuire <mcguire AT neurotica DOT com>
User-Agent: Mozilla/5.0 (X11; Linux x86_64; rv:10.0.2) Gecko/20120216 Thunderbird/10.0.2
MIME-Version: 1.0
To: geda-user AT delorie DOT com
Subject: Re: [geda-user] soldermask and edge connectors
References: <1332124007 DOT 10525 DOT 0 AT kwak> <alpine DOT DEB DOT 2 DOT 00 DOT 1203182229570 DOT 23342 AT zaphod DOT 661 DOT org> <4F66D542 DOT 3050404 AT keensupport DOT net> <alpine DOT DEB DOT 2 DOT 00 DOT 1203190126470 DOT 23342 AT zaphod DOT 661 DOT org>
In-Reply-To: <alpine.DEB.2.00.1203190126470.23342@zaphod.661.org>
Reply-To: geda-user AT delorie DOT com

On 03/19/2012 04:30 AM, David Griffith wrote:
>>>>> I'm trying to make an edge connector footprint. First, I want to
>>>>> make sure that the soldermask is clear of the fingers except at the
>>>>> root where traces connect.
>>>>
>>>> Do the connector footprint with two pads per finger. Reduce mask size
>>>> of one pad to zero vie the command line interface.
>>>
>>> I tried this and the result was soldermask going everywhere but the
>>> finger. I want the entire area where the fingers are clear of
>>> soldermask. I can do that by increasing the mask clearance, but I get
>>> scalloped edges.
>
> I think I garbled myself with this one. When I converted the buffer to
> an element, I then changed the pins from round to square. This cured the
> problem of scalloped edged of soldermask. I still have a problem with
> the need to cover part of the fingers with soldermask. There's also an
> issue with soldermask. Two fingers are longer than the rest, extending
> to the very edge of board whereas the other fingers are set back
> slightly. How can I make sure the empty area between the fingers and the
> edge is kept clear of soldermask?

   This is just an off-the-wall idea, but would it make sense to use an 
unused layer, place a polygon on it, tell pcb to clear the soldermask 
around that polygon, and then just don't use that layer for anything 
else?  Make it a sort of "soldermask keep-away layer".  Then just don't 
send that gerber file to fab.

             -Dave

-- 
Dave McGuire, AK4HZ
New Kensington, PA

- Raw text -


  webmaster     delorie software   privacy  
  Copyright © 2019   by DJ Delorie     Updated Jul 2019