X-Authentication-Warning:	delorie.com: mail set sender to geda-help-bounces using -f
X-Authentication-Warning:	envy.delorie.com: dj set sender to dj AT delorie DOT com using -f
From:	DJ Delorie <dj AT delorie DOT com>
To:	geda-help AT delorie DOT com
Subject:	Re: [geda-help] PCB: bottom layer split
In-Reply-To:	<alpine.LFD.2.20.1901131748370.24356@kai.zorinco.com> (geda-help@delorie.com)
Date:	Sun, 13 Jan 2019 20:56:28 -0500
Message-ID:	<xnk1j8dmsz.fsf@envy.delorie.com>
MIME-Version:	1.0
Reply-To:	geda-help AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-help AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

"Christopher Nielsen (chris AT zorinco DOT com) [via geda-help AT delorie DOT com]"
<geda-help AT delorie DOT com> writes:
> That exact line is in the pcb files... I'll play with changing those and 
> see if it helps. Or install the new software. I don't recall having these 
> issues before, but one thing is, it's a new install.

That might mean there's something unusual with your setup or flow,
though.  It would be nice to understand it and solve it rather than
switch software.

> pcb-rnd will probably solve it.

Well, probably, because pcb-rnd is at this point pretty much completely
different software.

- Raw text -