www.delorie.com/archives/browse.cgi   search  
Mail Archives: djgpp/2002/01/29/09:01:48

X-Authentication-Warning: delorie.com: mailnull set sender to djgpp-bounces using -f
From: Hans-Bernhard Broeker <broeker AT physik DOT rwth-aachen DOT de>
Newsgroups: comp.os.msdos.djgpp
Subject: Re: More Info
Date: 29 Jan 2002 13:39:10 GMT
Organization: Aachen University of Technology (RWTH)
Lines: 28
Message-ID: <a368lu$arl$1@nets3.rz.RWTH-Aachen.DE>
References: <3C561045 DOT 42E04404 AT xtra DOT co DOT nz> <3c561138 DOT sandmann AT clio DOT rice DOT edu> <3C563CFF DOT AF5763D6 AT xtra DOT co DOT nz>
NNTP-Posting-Host: acp3bf.physik.rwth-aachen.de
X-Trace: nets3.rz.RWTH-Aachen.DE 1012311550 11125 137.226.32.75 (29 Jan 2002 13:39:10 GMT)
X-Complaints-To: abuse AT rwth-aachen DOT de
NNTP-Posting-Date: 29 Jan 2002 13:39:10 GMT
Originator: broeker@
To: djgpp AT delorie DOT com
DJ-Gateway: from newsgroup comp.os.msdos.djgpp
Reply-To: djgpp AT delorie DOT com

Greg & Steph <gswhite AT xtra DOT co DOT nz> wrote:
> Hi again,
>          Go32-v2 runs ok, DPMI mem available 13457Kb, DPMI swap space
> available 47235Kb. Dos ver 6.22.

Looks sane

> Config.sys...
> Autoexec.bat...

Both look sane.

> Typing "rhide" results in...
> General Protection Fault at eip=233; flags=3206
[...]
> "gcc hello.c -o hello.exe" results in...
> Exiting due to signal SIGSEGV 
> General Protection Fault at eip=00000237	eax=00000018

One rather suspicious detail is that the eip of the crashing
instruction is almost the same in both cases.  As you're using DOS,
this might even be the exact same byte of RAM chip holding the failing
instruction.  That suggests you may well have a hardware instability
problem, quite probably bad RAMs.  Go check your memory chips, or any
other hardware you added to that machine recently.
-- 
Hans-Bernhard Broeker (broeker AT physik DOT rwth-aachen DOT de)
Even if all the snow were burnt, ashes would remain.

- Raw text -


  webmaster     delorie software   privacy  
  Copyright © 2019   by DJ Delorie     Updated Jul 2019