Mail Archives: djgpp/1998/02/13/14:22:34
apothegm AT softcom DOT net wrote:
As until now I didn't saw the Dim's reply I'll try to help you:
> I've downloaded and compiled DZComm, but I can't get its included
> terminal program to actually /do/ anything. I edited term.ini
> appropriately for com 1 (irq=4, address=0x3f8) but the program refused to
> acknowledge the usual modem commands (AT &F, ATDTXXX-XXXX, in particular)
> and left the modem unusable to other programs when I quit (I had to cold
> reboot in order to access the modem).
>
> I have a 14.4, nothing weird, and compiled with DZComm 0.41 and Allegro
> 3.0 beta (same stuff DZComm was tested with, according to its docs). I
> also tried editing term.c and removing all the mouse code, but the
> results were the same. I did follow the installation instructions in the
> docs (at least, I don't think I missed anything).
>
> Any suggestions? Any other comm libraries that are a little
> more...reliable?
DZComm is the best I know, even more if you use it with Palantir (multitasking
+ events, yes!). But 0.41 have some problems.
You must download 0.5, but you can try the following right now:
1) Use NO flow control (look in the header for the flag, XON/XOFF isn't
suitable for it and RTS/CTS have a bug in 0.5).
2) Reduce the baud rate to 9600 (the commands are sent to the modem at low
speed normally, you then switch the speed when the modem is connected to the
other end, new modems doesn't need it).
SET
------------------------------------ 0 --------------------------------
Visit my home page: http://set-soft.home.ml.org/
or
http://www.geocities.com/SiliconValley/Vista/6552/
Salvador Eduardo Tropea (SET). (Electronics Engineer)
Alternative e-mail: set-sot AT usa DOT net - ICQ: 2951574
Address: Curapaligue 2124, Caseros, 3 de Febrero
Buenos Aires, (1678), ARGENTINA
TE: +(541) 759 0013
- Raw text -