Message-Id:	<s1ca6c2d.038@MAIL.TAIT.CO.NZ>
Date:	Fri, 21 Jun 1996 09:32:38 +1200
From:	Bill Currie <bill_currie AT MAIL DOT TAIT DOT CO DOT NZ>
To:	mwallace AT skyler DOT wiltel DOT com
Cc:	djgpp AT delorie DOT com
Subject:	Re: Assembly

On 19/6/96  10:34 am, <mwallace AT skyler DOT wiltel DOT com> did thus say >>>
> 
> I am trying to port an assembly routine to DJGPP.  However,
> DJGPP does not recognize the op code I'm trying to use.
> 
> The code is "shrd edx, eax, 16".  I don't know that much
> about assembly.  How do I simulate this using other op
> codes?
> 
> Thanks.
> 
> michael DOT wallace AT wcom DOT com
> 

use shrd $16,%eax,%edx (assuming %edx is the destination)

I'm thinking that someone (or more) should compile a listing of all valid gas
instructions (I'm willing to help as I can provide some of the information
myself).  This should probably be a section in the FAQ (sure, there is some info
in info, but it doesn't tell you everything).

Bill

- Raw text -