From:	Erik Johnson <erik AT microware DOT com>
Date:	Thu, 1 Jul 93 15:32:41 CDT
To:	djgpp-announce AT sun DOT soe DOT clarkson DOT edu, rth AT sparta DOT com
Subject:	Re: Compile Speed Problems?

 	Date: Thu, 1 Jul 93 11:10:50 -0400
	From: rth AT sparta DOT com (Robert T. Harris)
	Message-Id: <9307011510 DOT AA06672 AT sparta DOT com>
	To: djgpp-announce AT sun DOT soe DOT clarkson DOT edu
	Subject: Compile Speed Problems?
	Status: R

	I just started fiddling with the DJGPP version 110 software and have a
	problem compiling almost any program within a reasonable amount of time.
	I have the software loaded on a 386DX-25MHZ machine with 8 Megs of physical
	memory using ST-277-1 (28ms) disk drives.  Even compiling main(void){}
	resulted in 3 minute compiles.  I let the compiler thrash on the sample
	programs (3 hour compiles) last night.  I tried with QEMM386 and with 
	HIMEM.SYS (using extended memory) with the same results.  I have previously
	used the GCC compiler under the linux operating system with normal results
	(i.e compiles within seconds) and of course Borland C++.  I am sending this
	message not to complain but to ask - what have I missed?  Is the DJGPP really
	this slow?  I have set up the tmp file on drive C: while the compiler and
	source code reside on drive D: - looking at the lights on the drives it 
	appears that significant paging is occuring.  I am using Stacker 3.0 on
	both drives C and D - any clues?  

						Bob Harris
						
DJGCC should not be this slow.

Check to make sure that you have PLENTY of conventional RAM before you
compile.  Run 'mem' right before you compile, and see what it gives
you.  Your make program may be using a lot of memory.  I used to use
Borland 3.1 make, and experienced very slow compile times.  Then I
cleaned up my autoexec.bat and switched to dmake.  Compile times
improved significantly.

Erik R Johnson     erik AT microware DOT com

- Raw text -