X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
Date: Thu, 11 Oct 2012 11:58:13 -0400
Message-Id: <201210111558.q9BFwDN2025308@envy.delorie.com>
From: DJ Delorie <dj AT delorie DOT com>
To: geda-user AT delorie DOT com
In-reply-to: <20121011155417.13405.qmail@stuge.se> (message from Peter Stuge
	on Thu, 11 Oct 2012 17:54:17 +0200)
Subject: Re: [geda-user] Flex?
References: <20121011143959 DOT 7435 DOT qmail AT stuge DOT se> <1349967212 DOT 2412 DOT 37 DOT camel AT AMD64X2 DOT fritz DOT box> <20121011155417 DOT 13405 DOT qmail AT stuge DOT se>
Reply-To: geda-user AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-user AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com
Precedence: bulk


> What is the solution? I guess the arcs need to start further out
> towards the corners. (One half line width diagonally in from each
> corner.)

The solution is to use rounded pads instead of square ones :-)

The teardrops math isn't *that* hard if you want to play with it.  I
never added square pad support because I didn't need it for the
problem I was trying to solve (I broke a trace inserting a part into a
too-small hole once).