Mailing-List: contact cygwin-help AT sourceware DOT cygnus DOT com; run by ezmlm
List-Subscribe: <mailto:cygwin-subscribe AT sources DOT redhat DOT com>
List-Archive: <http://sources.redhat.com/ml/cygwin/>
List-Post: <mailto:cygwin AT sources DOT redhat DOT com>
List-Help: <mailto:cygwin-help AT sources DOT redhat DOT com>, <http://sources.redhat.com/ml/#faqs>
Sender: cygwin-owner AT sources DOT redhat DOT com
Delivered-To: mailing list cygwin AT sources DOT redhat DOT com
Date: Thu, 1 Feb 2001 09:02:35 -0500
From: Christopher Faylor <cgf AT redhat DOT com>
To: cygwin AT cygwin DOT com
Subject: Re: Exception: STATUS_ACCESS_VIOLATION at eip=004C3F6F
Message-ID: <20010201090235.G4545@redhat.com>
Reply-To: cygwin AT cygwin DOT com
Mail-Followup-To: cygwin AT cygwin DOT com
References: <3A78F5E3 DOT F48F4D78 AT highley-recommended DOT com>
Mime-Version: 1.0
Content-Type: text/plain; charset=us-ascii
Content-Disposition: inline
User-Agent: Mutt/1.3.11i
In-Reply-To: <3A78F5E3.F48F4D78@highley-recommended.com>; from dhighley@highley-recommended.com on Wed, Jan 31, 2001 at 09:36:35PM -0800

On Wed, Jan 31, 2001 at 09:36:35PM -0800, David Highley wrote:
>When running the apell program I received the error,
>Exception: STATUS_ACCESS_VIOLATION at eip=004C3F6F
>There were also values for main and termination point on the screen.

I don't know what the "apell" program is but the error is occuring in
the program itself.

>This program has been running fine until I updated the Cygwin
>installation.  I have attached the stack dump and the portion of
>the setup.log file for the down loads that effected the running of
>this application.
>
>I did try rebuilding the application to see if there was a library
>change that might have caused the problem.

Did you try debugging the problem with gdb?

>I attempted to use the setup utility to revert to previous versions of
>each down load one at a time to try and isolate the problem, but I
>ran into troubles when I attempted this. I ended up hand editing
>the setup.ini file, removing the install and re-installing to get
>things running again.

Reverting to a previous version is not an "attempt to isolate the problem".
This is, instead, a "close your eyes and hope that someone else fixes the
problem".

cgf

--
Want to unsubscribe from this list?
Check out: http://cygwin.com/ml/#unsubscribe-simple