Mailing-List: contact cygwin-help AT sourceware DOT cygnus DOT com; run by ezmlm List-Subscribe: List-Archive: List-Post: List-Help: , Sender: cygwin-owner AT sourceware DOT cygnus DOT com Delivered-To: mailing list cygwin AT sourceware DOT cygnus DOT com From: jorg DOT schaible AT db DOT com Subject: problems building cygwin from src tarball To: cygwin AT sourceware DOT cygnus DOT com Date: Thu, 15 Jun 2000 19:29:21 +0000 Message-ID: X-MIMETrack: Serialize by Router on sdbo1003/DMGUK/DeuBaInt/DeuBa(Release 5.0.3 (Intl)|21 March 2000) at 15/06/2000 07:29:24 PM MIME-Version: 1.0 Content-type: text/plain; charset=iso-8859-1 Content-Transfer-Encoding: 8bit X-MIME-Autoconverted: from quoted-printable to 8bit by delorie.com id OAA31939 Hi, what is the propesed procedure to build the cygwin-1.2.2 from the source tarball in latest. Naivly I downloaded the file, extracted the files into /src, went into /src/cygwin-1.2.2, run ./configure, and than make. Make stops complaining not finding install-sh ... OK, there were some messages in the list some time ago concerning the missing install-sh. Next try: After cleaning up the complete /src and reinstalling the cygwin source tarball: Switch into /src/cygwin-1.2.2, mkdir bld, cd bld, ../configure and then make ... fine, seems to work much better - unfortunately after some time make stops complaining about missing commands texinfo, texi2html, db2html ... I seem to miss something still ... A short check proves that the files are not part of the texinfo.tar.gz ... ? Greetings, Jörg -- Want to unsubscribe from this list? Send a message to cygwin-unsubscribe AT sourceware DOT cygnus DOT com