Mailing-List: contact cygwin-help AT sourceware DOT cygnus DOT com; run by ezmlm
Sender: cygwin-owner AT sourceware DOT cygnus DOT com
List-Unsubscribe: <mailto:cygwin-unsubscribe-archive-cygwin=delorie DOT com AT sourceware DOT cygnus DOT com>
List-Archive: <http://sourceware.cygnus.com/ml/cygwin/>
List-Help: <mailto:cygwin-help AT sourceware DOT cygnus DOT com>,
	<http://sourceware.cygnus.com/ml/#faqs>
Delivered-To: mailing list cygwin AT sourceware DOT cygnus DOT com
Date: Thu, 5 Aug 1999 13:04:05 -0400 (EDT)
From: Hans - Dulimarta <dulimart AT egr DOT msu DOT edu>
X-Sender: dulimart AT scully
To: cygwin AT sourceware DOT cygnus DOT com
Subject: Accessing serial port.
Message-ID: <Pine.GSO.4.10.9908051257330.12515-100000@scully>
MIME-Version: 1.0
Content-Type: TEXT/PLAIN; charset=US-ASCII


I am porting my C codes from DJGPP to Cygwin. One of the modules has
several lines which read and write to COM1. I rewrite the code using
open ("/dev/com1"), read (....), write (....), etc. However, the code
seems to hang. The exact same code works fine under Linux by replacing
"/dev/com1" to "/dev/ttyS0". 

Could somebody please help me out.
Thanks.


Hans Dulimarta, Ph.D.    [dulimart AT egr DOT msu DOT edu, dulimart AT computer DOT org]
Visiting Research Associate
Department of Electrical & Computer Engineering         (517) 432-7589
Michigan State University, East Lansing, Michigan 48824


--
Want to unsubscribe from this list?
Send a message to cygwin-unsubscribe AT sourceware DOT cygnus DOT com