Mailing-List: contact cygwin-help AT sourceware DOT cygnus DOT com; run by ezmlm
Sender: cygwin-owner AT sourceware DOT cygnus DOT com
Delivered-To: mailing list cygwin AT sourceware DOT cygnus DOT com
Date: Wed, 23 Jun 1999 14:17:56 -0400
From: edinp AT mailhost DOT imagine-sw DOT com (Edin Pjetrovic)
Message-Id: <99Jun23.142827edt.11651-1@gateway.imagine-sw.com>
To: cygwin AT sourceware DOT cygnus DOT com
Subject: Cygwin
Mime-Version: 1.0
Content-Type: text/plain; charset=us-ascii
Content-Transfer-Encoding: 7bit
Content-Md5: qHZ0m6uSPaRuCTc8dXrVtw==

Hi,

I downloaded the Cygwin software on my Windows NT PC.  I would like to run a UNIX 
shell program that calls some other shell scripts in the same folder from my PC.  
When I go into a Unix shell from a Dos prompt the only way I can execute the 
program is by typing:

$ sh dbutil

instead of just:

$ dbutil.

When this (dbutil) scripts starts executing it then calls a couple of other scripts 
in the same folder but I then get an error the these scipt names are not found but 
they are in the same directory.

I think it's because I just can execute a Unix shell script from the command line 
without the 'sh' in front of it.

Please help if you have any idea what I should do.

Thank You very much.

Regards,

Edin Pjetrovic
New York, NY

--
Want to unsubscribe from this list?
Send a message to cygwin-unsubscribe AT sourceware DOT cygnus DOT com