X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
X-Mailer:	exmh version 2.8.0 04/21/2012 with nmh-1.7+dev
X-Exmh-Isig-CompType:	repl
X-Exmh-Isig-Folder:	inbox
From:	"karl AT aspodata DOT se [via geda-user AT delorie DOT com]" <geda-user AT delorie DOT com>
To:	geda-user AT delorie DOT com
Subject:	Re: [geda-user] export eps, clips too much
In-reply-to:	<20210811134237.314d5436@queeg.menasians.com>
References:	<20210810170005 DOT 6815083DF0CC AT turkos DOT aspodata DOT se> <20210811165705 DOT 4678580C6FA7 AT turkos DOT aspodata DOT se> <20210811134237 DOT 314d5436 AT queeg DOT menasians DOT com>
Comments:	In-reply-to "Stephen C. Menasian (menasian AT ptd DOT net) [via geda-user AT delorie DOT com]" <geda-user AT delorie DOT com>
	message dated "Wed, 11 Aug 2021 13:42:37 -0400."
Mime-Version:	1.0
Message-Id:	<20210811201724.295B880C6FA9@turkos.aspodata.se>
Date:	Wed, 11 Aug 2021 22:17:24 +0200 (CEST)
X-Virus-Scanned:	ClamAV using ClamSMTP
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

Stphen C. Menasian:
> On my gschem 1.10.2 (g5a69d90):
> 
> If I export to pdf, all 4 sides are slightly clipped.
> The titleblock (and frame) borders do not show up if I open the file with
> xpdf or acroread.
> 
> Maybe related?

Yes, I guess very much so.

For full page schematics, I use a "titleblock" symbol with two lines at
each corner indicating where the paper limit is and then exporting it
margin-less.
 Example:
http://aspodata.se/git/openhw/share/gschem/_graphical/A3liggande_s2.sym

In that case it doesnt matter if thoose corner lines doesn't show up,
since thay are there just for scaling, but with an eps included 
middocument it is really annoying if any content goes missing.
I had one that worked at -0.1mm margin, but when I adjusted the
makefile rule to 0.2 to accomondate another figure, that one was
clipped again even though the margin was set larger.

As a workoround I can use a margin of 0.2mm all around, but it is a 
trial an error thing.

My guess this is due to how cairo handles things, but don't know how
to verify that without starting to test it out.

Regards,
/Karl Hammar

- Raw text -