X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
X-Injected-Via-Gmane:	http://gmane.org/
To:	geda-user AT delorie DOT com
From:	Kai-Martin Knaak <kmk AT familieknaak DOT de>
Subject:	Re: [geda-user] Set same to all the pins
Date:	Sun, 02 Jun 2013 18:59:27 +0200
Lines:	32
Message-ID:	<koftla$1lu$1@ger.gmane.org>
References:	<20130531200805 DOT 12560 AT gmx DOT com>
Mime-Version:	1.0
X-Complaints-To:	usenet AT ger DOT gmane DOT org
X-Gmane-NNTP-Posting-Host:	a89-182-189-182.net-htp.de
User-Agent:	KNode/4.4.11
Reply-To:	geda-user AT delorie DOT com

Patrick Dupre wrote:

> I am supposed to use Atl V to change the via size, but it does not
> work!
> 

Hover the mouse cursor over a via. Then:
  a) use [s] to increase the size of the copper ring of this via
  b) use [SHIFT-s] to decrease the size of the copper ring
  c) use [ALT-s] to increase the drill diameter
  d) use [SHIFT-ALT-s] to decrease the drill diameter

Many keyboard accels can be read from a dedicated menu of pcb:
	Info -> Key_Bindings

A comprehensive list of keyboard accels can be found at:
	http://wiki.geda-project.org/geda:pcb-quick_reference

There is a menu item to change the size of all vias in a selection:
	Select -> Change_size_of_selected_objects -> Vias_+10_mil
Similar menues exist for the drill diameter.

Alternatively, you can issue actions from the command interface. Type 
a colon to open the command input. Relevant commands are:
	ChangeSize(SelectedElements, value[, unit])
	ChangeDrillSize(SelectedPins|SelectedVias, value[, unit])

Hope, that helps,

---<)kaimartin(>---
-- 
Kai-Martin Knaak

- Raw text -