X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
X-Virus-Scanned:	amavisd-new at neurotica.com
Subject:	Re: [geda-user] pcb: pad clearance in polygon?
To:	geda-user AT delorie DOT com
References:	<a8d201ee-de06-e251-2ed3-626b933a1b18 AT neurotica DOT com>
	<20200926160525 DOT 2fbf3d7d AT swips DOT iqo DOT uni-hannover DOT de>
From:	"Dave McGuire (mcguire AT neurotica DOT com) [via geda-user AT delorie DOT com]" <geda-user AT delorie DOT com>
Message-ID:	<3a2e0447-10b2-a32c-ad69-3fecc606dabf@neurotica.com>
Date:	Sat, 26 Sep 2020 11:40:27 -0400
User-Agent:	Mozilla/5.0 (X11; Linux x86_64; rv:60.0) Gecko/20100101
	Thunderbird/60.6.1
MIME-Version:	1.0
In-Reply-To:	<20200926160525.2fbf3d7d@swips.iqo.uni-hannover.de>
X-MIME-Autoconverted:	from quoted-printable to 8bit by delorie.com id 08QFfF1R026710
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

On 9/26/20 10:05 AM, Kai-Martin Knaak wrote:
> "Dave McGuire (mcguire AT neurotica DOT com) [via geda-user AT delorie DOT com]"
> <geda-user AT delorie DOT com> schrieb am 25. September 2020:
> 
>> I placed it on the
>> solder side, and the clearance in the copper pour on that side of the
>> board is gone, the pads are in direct contact with the pour.  When
>> placed on the component side, the ring of clearance is intact as I
>> expected.
> 
> Maybe the polygon on "solder" is actually not part of the bottom side
> group of layers. You can check layer groups at
> 	File → Preferences → Layers → Groups

   Yup, that was it, I found it yesterday while looking at the file. 
Thanks!

              -Dave

-- 
Dave McGuire, AK4HZ
New Kensington, PA

- Raw text -