X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
X-Virus-Status:	Clean
X-Virus-Scanned:	clamav-milter 0.98.4 at av01.lsn.net
Message-ID:	<55AFA05D.2060706@ecosensory.com>
Date:	Wed, 22 Jul 2015 08:53:33 -0500
From:	John Griessen <john AT ecosensory DOT com>
User-Agent:	Mozilla/5.0 (X11; Linux x86_64; rv:31.0) Gecko/20100101 Icedove/31.7.0
MIME-Version:	1.0
To:	geda-user AT delorie DOT com
Subject:	Re: [geda-user] [OT] I need help with selecting components
References:	<1507220238 DOT AA03807 AT ivan DOT Harhan DOT ORG>
In-Reply-To:	<1507220238.AA03807@ivan.Harhan.ORG>
Reply-To:	geda-user AT delorie DOT com

On 07/21/2015 09:38 PM, Spacefalcon the Outlaw wrote:
> no explanation as to how
> much current or power draw one should expect when putting out the Tx
> signal power level


OK then.  5.5V X 2.5A is your power to deal with briefly.

If barrel connectors with their trough holes seem a hassle,
then just about any connector with two pins for + and two pins for return
will do...  I don't know a good rule of thumb for connector  pin currents
and sizes.  Mill-Max company might have good info on that for theirs, and
other kinds of pins might be less able, depending on gold plating and
heat flows and what-not.

- Raw text -