X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
Date:	Mon, 9 Mar 2015 21:09:07 +0100
From:	Stelian Pop <stelian AT popies DOT net>
To:	geda-user AT delorie DOT com
Subject:	Re: [geda-user] PCB autorouter doesn't create vias. Bug or user
	error ?
Message-ID:	<20150309200906.GA3021@calypso>
References:	<20150308125251 DOT GB3259 AT calypso>
	<CAOFvGD4m4wPg5dW0D+oKQyOy5_Fsozr=rG7+ts2fyMFPErOGxA AT mail DOT gmail DOT com>
	<201503081902 DOT t28J25cg025772 AT envy DOT delorie DOT com>
	<20150308201201 DOT GA3342 AT calypso>
	<20150308214212 DOT GB3342 AT calypso>
	<CAKakQcdHPHSV-OLe_PkyhkydxjgrO=LUCZnbeZroF9F0sb-_+A AT mail DOT gmail DOT com>
MIME-Version:	1.0
In-Reply-To:	<CAKakQcdHPHSV-OLe_PkyhkydxjgrO=LUCZnbeZroF9F0sb-_+A@mail.gmail.com>
User-Agent:	Mutt/1.5.23 (2014-03-12)
X-Virus-Scanned:	ClamAV using ClamSMTP
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

Hi,

On Tue, Mar 10, 2015 at 06:26:38AM +1100, Stephen Ecob wrote:
> I suggest that you run the autorouter before adding the plane, as the
> auotrouter will not cut into a plane for you.
> I haven't used the autorouter in years, but my normal flow with it was:
> 1. Fence off keep out areas with rectangles of copper.
> 2. Run the autorouter
> 3. Tidy up traces with the trace optimisers
> 4. Convert autorouted traces that should be planes/partial planes by
> finding them, selecting found, removing the clearline flag, then overlaying
> them with copper polygons.

Thanks for your suggestion, I finally ended up using a slightly
different approach:

1. disable GND in the netlist window
2. select only the top layer
3. run the autorouter. Most of the rats will be routed, except a few
4. select the bottom layer
5. run the autorouter again, laying out the remaining rats
6. draw the rectangle for the ground plane

Stelian.
-- 
Stelian Pop <stelian AT popies DOT net>

- Raw text -