X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
X-Cam-AntiVirus:	no malware found
X-Cam-ScannerInfo:	http://www.cam.ac.uk/cs/email/scanner/
Message-ID:	<1420674867.19878.4.camel@cam.ac.uk>
Subject:	Re: gcode / CNC and PCB Was: [Re: [geda-user] Refactoring in PCB]
From:	Peter Clifton <pcjc2 AT cam DOT ac DOT uk>
To:	geda-user AT delorie DOT com
Date:	Wed, 07 Jan 2015 23:54:27 +0000
In-Reply-To:	<u3L.JOL0.ImUgzHRMa2.1KhP5c@seznam.cz>
References:	<87wq4yxy0t DOT fsf AT rover DOT gag DOT com>
	<1420505387 DOT 3521 DOT 10 DOT camel AT cam DOT ac DOT uk> <20150106180051 DOT 12514 DOT qmail AT stuge DOT se>
	<1420586390 DOT 14239 DOT 10 DOT camel AT cam DOT ac DOT uk>
	<153222ccbb5462fe8d2172a2df9b1b0e AT cam DOT ac DOT uk>
	<u3L DOT JOL0 DOT ImUgzHRMa2 DOT 1KhP5c AT seznam DOT cz>
X-Mailer:	Evolution 3.12.7-0ubuntu1
Mime-Version:	1.0
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

On Wed, 2015-01-07 at 21:04 +0100, Vaclav Peroutka wrote:
> 
>         What was wrong with PCB's gcode export?
>         
>         Peter
> 
> 
> Hi, two months ago I filled in several bug reports regarding gcode
> export.  They are as follows:
> 
> https://bugs.launchpad.net/pcb/+bug/1390439
> 
> https://bugs.launchpad.net/pcb/+bug/1390442
> 
> https://bugs.launchpad.net/pcb/+bug/1390450
> 
> https://bugs.launchpad.net/pcb/+bug/1390452
> 
> 
> If you have any questions, do not bother to ask me either through
> Launchpad or here.

Did you mean "do no hesitate to ask?"? ("do not bother") would mean the
opposite.

Can you suggest a simple (easy to find / install) gcode viewer I can
verify the test-cases against?


FWIW, it may be intentional that the drilling of the PCB is done from
the bottom. For people making single-sided boards with through-hole
components, the normal position for the copper is on the "bottom" layer
group.

This would probably make the bottom side the preferred direction to
drill from. (IE, the side where the tracks are milled, on the bottom of
the board).

Kind regards,

-- 
Peter Clifton <peter DOT clifton AT clifton-electronics DOT co DOT uk>

Clifton Electronics

- Raw text -