X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
X-Virus-Scanned:	amavisd-new at neurotica.com
Message-ID:	<50888263.8010105@neurotica.com>
Date:	Wed, 24 Oct 2012 20:05:55 -0400
From:	Dave McGuire <mcguire AT neurotica DOT com>
User-Agent:	Mozilla/5.0 (X11; Linux x86_64; rv:16.0) Gecko/20121011 Thunderbird/16.0.1
MIME-Version:	1.0
To:	geda-user AT delorie DOT com
Subject:	Re: [geda-user] Trace width - best practices?
References:	<20121023192443 DOT GK524 AT fi DOT muni DOT cz> <CAKakQccEOLFD0bbe6ydry-6YN7xsvjJAcbrTSt6DAYHJN-ohrA AT mail DOT gmail DOT com> <20121024113238 DOT GP32696 AT fi DOT muni DOT cz> <201210241842 DOT q9OIgOlN001120 AT envy DOT delorie DOT com>
In-Reply-To:	<201210241842.q9OIgOlN001120@envy.delorie.com>
X-Enigmail-Version:	1.4.5
Reply-To:	geda-user AT delorie DOT com

On 10/24/2012 02:42 PM, DJ Delorie wrote:
>> However, I can offer my students to do some improvements to gEDA as
>> 	OK, I will try to route the wide paths manually, but I am probably
>> no match for the pcb autorouter :-)
> 
> You'd be surprized - I typically do *not* use the autorouter because I
> can do a better job (although not nearly a *faster* job, assuming the
> autorouter can complete the task at all)

  Same here; I do all my boards by hand.  I'm not knocking the
autorouter, but I do take a bit of "artistic pride" in my PCB layouts.
Electrical requirements come first of course, but people look at my
boards and say "wow, that's pretty!"

             -Dave

-- 
Dave McGuire, AK4HZ
New Kensington, PA

- Raw text -