X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
Message-ID:	<4FBE499D.2090509@laserlinc.com>
Date:	Thu, 24 May 2012 10:45:49 -0400
From:	Joshua Lansford <Joshua DOT Lansford AT laserlinc DOT com>
User-Agent:	Mozilla/5.0 (X11; Linux i686; rv:12.0) Gecko/20120428 Thunderbird/12.0.1
MIME-Version:	1.0
To:	geda-user AT delorie DOT com
Subject:	[geda-user] Chassis ground vs Circuit ground
Reply-To:	geda-user AT delorie DOT com

Hello.
    I have an Ethernet Jack with a separate chassis ground.  The grounds 
connect by zero ohm resistors beside the jack.  Supposedly this keeps 
noise from following the cable onto board.  I saw somewhere not connect 
chassis and  together on the board but though the enclosure.  The card 
with plated edges slides into a metal extrusion.  Should both edges be 
chassis ground or should one be circuit ground?   This supposedly keeps 
a DC difference from developing but dissipates noise.  What are your 
opinions about how to deal with chassis ground vs circuit ground?
~Joshua

- Raw text -