X-Authentication-Warning:	delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient:	geda-user AT delorie DOT com
MIME-Version:	1.0
In-Reply-To:	<CAKakQccfDYfPqi9qY0mxjgtoFC9x3WweOJBpd3rhzGuQ1C5P1Q@mail.gmail.com>
References:	<1320692655 DOT 6963 DOT 20 DOT camel AT localhost>
	<CAKakQccfDYfPqi9qY0mxjgtoFC9x3WweOJBpd3rhzGuQ1C5P1Q AT mail DOT gmail DOT com>
Date:	Mon, 7 Nov 2011 14:04:43 -0700
Message-ID:	<CAN0Jx-8WVgStP=DPZBAZoZEv4+qqCV-+KwaS5Xo3EY+3URBrLw@mail.gmail.com>
Subject:	Re: [geda-user] PCIe card?
From:	Russell Dill <Russ DOT Dill AT asu DOT edu>
To:	geda-user AT delorie DOT com
X-MIME-Autoconverted:	from quoted-printable to 8bit by delorie.com id pA7L4lm1007715
Reply-To:	geda-user AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-user AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

> One idea I had for a quick start was to lay out and edit a PCB with
> the differential pairs replaced by fat single traces of thickness (2 *
> differential trace copper thickness + differential trace internal
> spacing).  A fairly simple bit of code could later convert these from
> fat single traces to differential pairs.

BTW, it isn't really necessary to route differential traces this way.
Rather than route them with a very tightly regulated spacing, you can
route them instead with a minimum spacing as single ended traces,
which is much easier. Just be sure they have equal lengths impedances.

- Raw text -