X-Authentication-Warning:	delorie.com: mail set sender to geda-help-bounces using -f
X-Recipient:	geda-help AT delorie DOT com
DKIM-Signature:	v=1; a=rsa-sha256; c=relaxed/relaxed;
	d=gmail.com; s=20120113;
	h=mime-version:in-reply-to:references:date:message-id:subject:from:to
	:content-type;
	bh=x86zIopHbN/uF6/UVTKNG3wmyu3O1UAke9rqpjodC3M=;
	b=g2H9kUeyYNZMe8q8K4ZCtm5NNdGil05pChsuQkKMwHxStctqagxu5iN7WDxNcglb5d
	8njGxXiGULqaOGq/BFLBhMTov928cNiWUxrL96sisDLf37SBeJffG1/W8S/+0vLQWCnr
	ms1aNl7ep/5dnIlF1+l+L5PATRpNF3rMXglVN7VC9VClNvM9Hr1Od6jHWL/7n/KTJsoZ
	5TF6VxKHvZQ8hETuNSA9KYZZh8yCU4b1pzOQ5OJbiEvsgMe4kXb3JZxbMmIqpeOioEkH
	rbJ7TouKaE9OaJg7Z34Fc+zuNXnzDGvTXXikrmZRSiCZJZzbfoR+i1ezz6N+Yjw76Okt
	tTRA==
MIME-Version:	1.0
X-Received:	by 10.50.97.33 with SMTP id dx1mr14620640igb.4.1412790872060; Wed,
	08 Oct 2014 10:54:32 -0700 (PDT)
In-Reply-To:	<685015500.1106923.1412786931337.JavaMail.yahoo@jws10651.mail.bf1.yahoo.com>
References:	<1412784061 DOT 2815 DOT 98 DOT camel AT linetec>
	<685015500 DOT 1106923 DOT 1412786931337 DOT JavaMail DOT yahoo AT jws10651 DOT mail DOT bf1 DOT yahoo DOT com>
Date:	Wed, 8 Oct 2014 13:54:31 -0400
Message-ID:	<CAOuGh8-D4zjO1Ur-QJNDB2j=ixWMX4Linv6cLGEc7wD8hbyJKg@mail.gmail.com>
Subject:	Re: [geda-help] Panelizing howto or examples?
From:	Bob Paddock <graceindustries AT gmail DOT com>
To:	geda-help AT delorie DOT com
Reply-To:	geda-help AT delorie DOT com
Errors-To:	nobody AT delorie DOT com
X-Mailing-List:	geda-help AT delorie DOT com
X-Unsubscribes-To:	listserv AT delorie DOT com

If the plan is to ever send a panel to a contractor to have the board
built by machine, the panel needs to have 'waste material' around the
perimeter of the panel.  Part of my fab notes:

Board fabricator shall place 1/4" waste material around all sided,
with 0.125" tooling hole in each corner of the waste materiel, of each
panel.

Board fabricator shall apply a minimum of four 0.060" fiducals on
waste material on a panel.

- Raw text -