Mailing-List:	contact cygwin-help AT sourceware DOT cygnus DOT com; run by ezmlm
List-Subscribe:	<mailto:cygwin-subscribe AT sourceware DOT cygnus DOT com>
List-Archive:	<http://sourceware.cygnus.com/ml/cygwin/>
List-Post:	<mailto:cygwin AT sourceware DOT cygnus DOT com>
List-Help:	<mailto:cygwin-help AT sourceware DOT cygnus DOT com>, <http://sourceware.cygnus.com/ml/#faqs>
Sender:	cygwin-owner AT sourceware DOT cygnus DOT com
Delivered-To:	mailing list cygwin AT sourceware DOT cygnus DOT com
From:	jorg DOT schaible AT db DOT com
Subject:	problems building cygwin from src tarball
To:	cygwin AT sourceware DOT cygnus DOT com
Date:	Thu, 15 Jun 2000 19:29:21 +0000
Message-ID:	<OF344A93D0.BA11B844-ON002568FF.0058A923@srv.uk.deuba.com>
X-MIMETrack:	Serialize by Router on sdbo1003/DMGUK/DeuBaInt/DeuBa(Release 5.0.3 (Intl)|21
	March 2000) at 15/06/2000 07:29:24 PM
MIME-Version:	1.0
X-MIME-Autoconverted:	from quoted-printable to 8bit by delorie.com id OAA31939

Hi,

what is the propesed procedure to build the cygwin-1.2.2 from the source tarball in latest. Naivly I downloaded the file, extracted the files into /src, went into /src/cygwin-1.2.2, run ./configure, and than make. Make stops complaining not finding install-sh  ... OK, there were some messages in the list some time ago concerning the missing install-sh.

Next try: After cleaning up the complete /src and reinstalling the cygwin source tarball: Switch into /src/cygwin-1.2.2, mkdir bld, cd bld, ../configure and then make ... fine, seems to work much better - unfortunately after some time make stops complaining about missing commands texinfo, texi2html, db2html ... I seem to miss something still ...

A short check proves that the files are not part of the texinfo.tar.gz ... ?

Greetings,
Jörg


--
Want to unsubscribe from this list?
Send a message to cygwin-unsubscribe AT sourceware DOT cygnus DOT com

- Raw text -