Buy the book!
|[ < ]||[ > ]||[ << ]||[ Up ]||[ >> ]||[Top]||[Contents]||[Index]||[ ? ]|
A global break condition stops execution when a specified
condition is satisfied, no matter where that may occur. Edebug
evaluates the global break condition at every stop point; if it
evaluates to a non-
nil value, then execution stops or pauses
depending on the execution mode, as if a breakpoint had been hit. If
evaluating the condition gets an error, execution does not stop.
The condition expression is stored in
edebug-global-break-condition. You can specify a new expression
using the X command (
The global break condition is the simplest way to find where in your
code some event occurs, but it makes code run much more slowly. So you
should reset the condition to
nil when not using it.
|webmaster donations bookstore||delorie software privacy|
|Copyright © 2003 by The Free Software Foundation||Updated Jun 2003|