X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient: geda-user AT delorie DOT com
Message-ID: <20161015084405.26403.qmail@rahul.net>
Date: Sat, 15 Oct 2016 01:44:05 -0700
To: geda-user AT delorie DOT com
Subject: Re: [geda-user] Best way to use gerbv(1) for single layer DIY boards?
In-Reply-To: <20161015082035.25529.qmail@rahul.net>
References: <20161012013026 DOT 25221 DOT qmail AT rahul DOT net>
	<20161012023951 DOT 43F528126612 AT turkos DOT aspodata DOT se>
	<526c176c-62b4-9219-3919-83df144acc37 AT ecosensory DOT com>
	<20161015040106 DOT 48C8B812661A AT turkos DOT aspodata DOT se>
	<20161015082035 DOT 25529 DOT qmail AT rahul DOT net>
X-Mailer: VM 7.19 under Emacs 23.4.1
From: conover AT rahul DOT net (John Conover)
MIME-Version: 1.0
Content-Type: text/plain; charset=US-ASCII
Content-Transfer-Encoding: 7bit
Reply-To: geda-user AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-user AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com
Precedence: bulk


How embarrassing. Checking multi-file works perfectly.

    John

John Conover writes:
> karl AT aspodata DOT se writes:
> > > On 10/11/2016 09:39 PM, karl AT aspodata DOT se wrote:
> > > > I get the drill-helper so I can aim better when drilling.
> 
> Thanks, Karl.
> 
> I need to send the postscript file to a commercial service to make the
> transparencies.
> 
> Is there a way to cut out the solder layer from the postscript file
> separately?
> 
> Gimp(1) seems to work, (however, I'm losing resolution with all the
> import/export manipulations.) Is there another way?
> 
>     Thanks,
> 
>     John
> 
> -- 
> 
> John Conover, conover AT rahul DOT net, http://www.johncon.com/

-- 

John Conover, conover AT rahul DOT net, http://www.johncon.com/