X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
Date: Thu, 19 May 2016 01:25:11 -0400
Message-Id: <201605190525.u4J5PBoX030635@envy.delorie.com>
From: DJ Delorie <dj AT delorie DOT com>
To: geda-user AT delorie DOT com
In-reply-to: <1463635108.16360.8.camel@ksys.co.nz> (message from Buzz on Thu,
	19 May 2016 17:18:28 +1200)
Subject: Re: [geda-user] Metric
References: <1463635108 DOT 16360 DOT 8 DOT camel AT ksys DOT co DOT nz>
Reply-To: geda-user AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-user AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com
Precedence: bulk


> Is there a way to get PCB to default to using mm rather than mils?

You can set the default grid to a mm grid in your ~/.pcb/settings:

grid = 1mm
grid-units = mm