X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
Date: Tue, 9 Feb 2016 00:12:44 -0500
Message-Id: <201602090512.u195CiwF024135@envy.delorie.com>
From: DJ Delorie <dj AT delorie DOT com>
To: geda-user AT delorie DOT com
In-reply-to:
	<CAC4O8c9pbaWEM=imUBC=QFKLd2dkMAB_ZYKCkaynYXQtC_n+yw AT mail DOT gmail DOT com>
	(geda-user AT delorie DOT com)
Subject: Re: [geda-user] is Vendor drill mapping still relevant?
References: <CAC4O8c9pbaWEM=imUBC=QFKLd2dkMAB_ZYKCkaynYXQtC_n+yw AT mail DOT gmail DOT com>
Reply-To: geda-user AT delorie DOT com


> Looks like this functionality was intended to automatically change pin
> and via sizes to nearby standard drill diameters.
> 
> I've never worried about setting hole sizes to please my board house
> and they've never complained.  I wonder if this stuff is still
> applicable nowadays?

As long as there are vendors that charge for off-rack drill sizes,
sure.