X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f X-Recipient: geda-user AT delorie DOT com From: "Wojciech Kazubski (wk AT ire DOT pw DOT edu DOT pl) [via geda-user AT delorie DOT com]" To: geda-user AT delorie DOT com Subject: Re: [geda-user] yet another footprint generator Date: Thu, 30 Jul 2015 18:09:28 +0200 Message-ID: User-Agent: KMail/4.14.9 (Linux/3.16.7-21-desktop; KDE/4.14.9; x86_64; ; ) In-Reply-To: References: MIME-Version: 1.0 Content-Transfer-Encoding: 7Bit Content-Type: text/plain; charset="us-ascii" X-Assp-Version: 2.4.5(15162) on ASSP.ire.pw.edu.pl X-Assp-ID: ASSP.ire.pw.edu.pl X-Assp-Session: 6A8A8210 (mail 1) X-Assp-Original-Subject: Re: [geda-user] yet another footprint generator X-Assp-Client-SSL: yes Reply-To: geda-user AT delorie DOT com Errors-To: nobody AT delorie DOT com X-Mailing-List: geda-user AT delorie DOT com X-Unsubscribes-To: listserv AT delorie DOT com Precedence: bulk > > Please add more pin numbering options to connector generator. The existing > > one can be named "d-sub" style, also "flat cable" and "dip" should be > > considered. > Two alternate numbering can be achieved by pivoting n and m: > > connector(2,3) and connector(3,2) will generate the same geometry 90 > degrees rotated but because of the pivot the numbering scheme (seems) > different. One is a mirror image of the other. Not a problem if one remembers to place the connector on the other side of the board. Additionally the "outer" mark is on short side of the connector instead of long one. > The "dip" numbering is not accessible this way, I will invent a parameter > for that, thanks for the idea! > > Regards, > > Igor2 -- dr Wojciech Kazubski Instytut Radioelektroniki Politechniki Warszawskiej