X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient: geda-user AT delorie DOT com
From: Thomas Stilwell <stilwellt AT openlabs DOT co>
To: geda-user AT delorie DOT com, Rob Butts <r DOT butts2 AT gmail DOT com>
Subject: Re: [geda-user] PCB parts not dragging to even grid spots
Date: Sat, 31 May 2014 17:18:07 -0500
Message-ID: <1889021.ufx5MQFX6c@neo>
User-Agent: KMail/4.13 (Linux/3.14.4-1-ARCH; KDE/4.13.0; x86_64; ; )
In-Reply-To: <CALSZ9gpvSm7PPc8iKDieO2PeZy1WtLL80qZhNfRw60SyQ-hhnA@mail.gmail.com>
References: <CALSZ9gpvSm7PPc8iKDieO2PeZy1WtLL80qZhNfRw60SyQ-hhnA AT mail DOT gmail DOT com>
MIME-Version: 1.0
Content-Transfer-Encoding: 7Bit
Content-Type: text/plain; charset="us-ascii"
Reply-To: geda-user AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-user AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com
Precedence: bulk

On Saturday 31 May 2014 16:16:43 you wrote:
> I've never had this problem.  I set the grid size in PCB to 25 mils and
> when I drag parts it will place them at non-rounded decimal places.  For
> example I drag a component to 2679.15 x.  How can I get it to place
> components on even multiples of 25?
> 
> Thanks!

Possibly you've used View>Realign_Grid to change the grid alignment?

I'm not sure if there's a more direct way to reset it back to default, but 
I've been able to reset it like this:

Set the Grid Size to No Grid
Select Realign Grid, then press Escape to cancel
Re-enable the grid