X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
X-Recipient: geda-user AT delorie DOT com
Date: Tue, 27 Dec 2011 22:08:06 -0500
From: gene glick <geneglick AT optonline DOT net>
Subject: Re: [geda-user] pcb slots
In-reply-to: <201112280256.pBS2uUdE025473@envy.delorie.com>
To: geda-user AT delorie DOT com
Message-id: <4EFA8816.5050809@optonline.net>
MIME-version: 1.0
Content-type: text/plain; charset=ISO-8859-1; format=flowed
Content-transfer-encoding: 7BIT
References: <4EFA7708 DOT 8090702 AT optonline DOT net>
 <201112280227 DOT pBS2R5qp024574 AT envy DOT delorie DOT com>
 <4EFA8435 DOT 5090303 AT optonline DOT net> <201112280256 DOT pBS2uUdE025473 AT envy DOT delorie DOT com>
User-Agent: Mozilla/5.0 (X11; U; Linux i686; en-US; rv:1.9.2.15) Gecko/20110323
 Thunderbird/3.1.9
Reply-To: geda-user AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-user AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com
Precedence: bulk

> Note that adding slots usually makes the board cost a lot more.  If
> you can, just use a large round hole instead.
>

Yep - I considered that.  Problem is that the connectors are close to 
one another and the holes would bump against each other - I think - 
maybe worth a second look.  The slots are like 3 mm long, and really narrow.

Hey - here's a thought. Maybe bend those things up at right angle 
instead, and add a surface pad to solder it to.  Or - snip the tabs off 
completely (or partially), and place some copper on the footprint along 
the edge of the connector. Then lay a bead of solder along the edges. 
The tabs are for mechanical support - I am reluctant to go without them.