X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
Date: Tue, 27 Dec 2011 21:56:30 -0500
Message-Id: <201112280256.pBS2uUdE025473@envy.delorie.com>
From: DJ Delorie <dj AT delorie DOT com>
To: geda-user AT delorie DOT com
In-reply-to: <4EFA8435.5090303@optonline.net> (message from gene glick on Tue,
	27 Dec 2011 21:51:33 -0500)
Subject: Re: [geda-user] pcb slots
References: <4EFA7708 DOT 8090702 AT optonline DOT net>
 <201112280227 DOT pBS2R5qp024574 AT envy DOT delorie DOT com> <4EFA8435 DOT 5090303 AT optonline DOT net>
Reply-To: geda-user AT delorie DOT com
Errors-To: nobody AT delorie DOT com
X-Mailing-List: geda-user AT delorie DOT com
X-Unsubscribes-To: listserv AT delorie DOT com
Precedence: bulk


For footprints, I suspect there's more than that involved in properly
supporting it in pcb, but as far as the fab is concerned, it's all
gerbers.

Note that adding slots usually makes the board cost a lot more.  If
you can, just use a large round hole instead.