X-Authentication-Warning: delorie.com: mail set sender to geda-user-bounces using -f
Date: Fri, 26 Oct 2012 17:00:45 -0400
Message-Id: <201210262100.q9QL0jej012618@envy.delorie.com>
From: DJ Delorie <dj AT delorie DOT com>
To: geda-user AT delorie DOT com
In-reply-to:
	<CAGde_xPS3DgAyWYU9_Ytfet9oXRzhOF9khXgKkPFH=rmkgprXA AT mail DOT gmail DOT com>
	(message from Svenn Are Bjerkem on Fri, 26 Oct 2012 14:29:43 +0200)
Subject: Re: [geda-user] FPGA / CPLD development with Linux
References: <1350863030 DOT 93187 DOT YahooMailNeo AT web121004 DOT mail DOT ne1 DOT yahoo DOT com>
	<20121022000634 DOT 10554 DOT qmail AT stuge DOT se>
	<1351201071 DOT 29496 DOT YahooMailNeo AT web121001 DOT mail DOT ne1 DOT yahoo DOT com> <CAGde_xPS3DgAyWYU9_Ytfet9oXRzhOF9khXgKkPFH=rmkgprXA AT mail DOT gmail DOT com>
Reply-To: geda-user AT delorie DOT com


> > By the way: is there an active IRC channel for discussion of this
> > sort of thing (i.e. open-source EDA)? The 'pcb' channel on
> > freenode has always seemed very quiet when I signed into it. (It's
> > generally less intimidating posing newbie questions on IRC than on
> > a mailing list.)
> 
> Stay tuned 7/24 and you will see messages from time to time on #pcb,
> but that channel is not dedicated to the geda-friend pcb. It's about
> pcb layout and prototyping in general, geda pcb included.

Note that #geda on OFTC is the official channel for all things gEDA.
I hang out there pretty much all the time.