From: ad354 AT FreeNet DOT Carleton DOT CA (James Owens)
Newsgroups: comp.compression,comp.os.msdos.djgpp
Subject: newbie question involving InfoZIP source and DJGPP
Date: 5 Nov 2000 18:45:36 GMT
Organization: The National Capital FreeNet
Lines: 24
Message-ID: <8u49sg$dbj$1@freenet9.carleton.ca>
NNTP-Posting-Host: freenet10
X-Trace: freenet9.carleton.ca 973449936 13683 134.117.136.30 (5 Nov 2000 18:45:36 GMT)
X-Complaints-To: complaints AT ncf DOT ca
NNTP-Posting-Date: 5 Nov 2000 18:45:36 GMT
X-Given-Sender: ad354 AT freenet10 DOT carleton DOT ca (James Owens)
To: djgpp AT delorie DOT com
DJ-Gateway: from newsgroup comp.os.msdos.djgpp
Reply-To: djgpp AT delorie DOT com

I downloaded InfoZIP source (5.41) and the DJGPP compiler (2.03) so that I
could compile a special DOS self-extraction stub UNZIPSFX.EXE.  I wanted
to enable the command line -d option, which lets you specify a destination
directory.  I finally succeeded, but there's something I don't understand.

According to the InfoZIP documentation, all I had to do was "define
SFX_EXDIR."  What I did, following hints here and there, was to un-comment
a line in the DJ2 makefile (EXDIR=-SFX_EXDIR) and add a line to my
AUTOEXEC.BAT (set LOCAL_ZIP=-SFX_EXDIR).

This worked -- but only if I started with a completely fresh unzip of the
INFOZIP downloadable, made these changes immediately, and then ran MAKE. 
If I ran MAKE with the unaltered source first, then my changes to the
files made no difference to subsequent compiles.  (I noticed that running
MAKE on a fresh unzip produced many more messages -- often DFUNZIP
messages -- than subsequent compiles).

Obviously I was doing something wrong.  How would one normally get a
slight change like this to compile?

--

                                     James Owens  ad354 AT Freenet DOT carleton DOT ca
                                     Ottawa, Ontario, Canada