Newsgroups: comp.os.msdos.djgpp From: pjbk AT cee DOT hw DOT ac DOT uk (Peter JB King) Subject: Emacs (again) Message-ID: Sender: news AT cee DOT hw DOT ac DOT uk (News Administrator) Organization: Dept of Computing & Electrical Engineering, Heriot-Watt University, Scotland Date: Fri, 18 Oct 1996 11:11:33 GMT Lines: 23 To: djgpp AT delorie DOT com DJ-Gateway: from newsgroup comp.os.msdos.djgpp Following the discussions of the ease with which emacs could be compiled using djgpp, I decided to give it a go, since emacs is the only reason for keeping my old v1 go32.exe around. Following the instructions, everything goes swimmingly, except for mv on the machine I was using not recognising -f, Anyway, I did those bits by hand, and everything appeared to work. However, when I attempt to run emacs, all I get is a long list of digits being output for about three screens worth, and then it exits (normally I think). Is there some obvious mistake I have made in configuration, or is it a subtle effect of my set up? All suggestions greatfully received. -- Peter King, Computing & Electrical Eng. Internet: pjbk AT cee DOT hw DOT ac DOT uk Heriot-Watt University, Riccarton, or P DOT J DOT B DOT King AT heriot-watt DOT ac DOT uk Edinburgh EH14 4AS, Scotland Phone: (+44) 131 451 3433 Fax: (+44) 131 451 3431